Brink Renovent filters
Original and compatible filters for 6 Brink Renovent models.
12 filter sets












Questions about Brink filters
Which Brink ventilation series do you supply filters for?
We carry replacement filter sets for Brink’s most common residential lines:
- Flair (225, 325/400, 450/600)
- Renovent Excellent (180, 300/400/500)
- Renovent Sky (150/200, 300)
- Renovent HR (250/325, with or without bypass)
All four are widely installed in the Netherlands and Belgium. The model name is usually printed on a label inside the front cover, next to the filter compartment.
How quickly can you deliver Brink replacement filters to the Netherlands or Belgium?
We ship Brink filters across the Netherlands and Belgium, with most orders arriving within a few business days. Ordering slightly ahead of your next scheduled filter change avoids running the unit on a saturated filter while you wait.
Do Renovent Excellent, Renovent Sky and Flair units all use the same filter size, or does it vary?
No — filter dimensions differ between the Renovent Excellent, Renovent Sky, Renovent HR and Flair series, and often between sizes within a series (for example, Flair 225, 325/400 and 450/600 each take their own set). Always match by your exact series and model, or measure your current filter directly, rather than assuming sizes carry across the Brink range.
My Brink unit shows a filter warning light — does that mean the filter is full?
Not necessarily. The filter indicator on Brink Flair and Renovent units is a maintenance reminder — on most models it comes on after a set number of operating hours, not because the filter has been measured as full. Check the filters visually, fit a new set if they are dirty, and reset the indicator from the unit’s control panel as described in your manual.
What filter class is recommended for Brink units?
It depends on the series. The Brink filter sets we stock come in these combinations:
- Flair and Renovent Sky — G4+G4, or G4+F7 with a fine F7 (ePM1) supply filter
- Renovent Excellent 300/400/500 — G3+G3, or G3+F7
- Renovent Excellent 180 and Renovent HR — G3+G3, or G3+M6
Choose the version with the finer supply filter (F7 or M6) for better protection against pollen and fine dust, for example near a busy road. The Flair 225 is available as G4+G4 only.
About Brink Renovent filters
The Brink Renovent range covers three distinct sub-series — Excellent, HR and Sky — each with its own filter dimensions and model line-up. This page is part of the wider Brink filter selection.
Choose your Renovent sub-series
- Renovent Excellent — 180 and 300/400/500 models, our most-searched Renovent line
- Renovent HR — 250/325 models, with and without bypass
- Renovent Sky — 150/200 and 300 models
Why Renovent filter sizes differ between sub-series
Excellent, HR and Sky units were built on different chassis generations, so their filter compartments are not interchangeable. A Renovent Excellent 180 filter will not fit a Renovent Sky 150/200 unit, even though both are Renovent-branded — always confirm the sub-series and exact model before ordering.
G4/G3 base filtration, with M6/F7 upgrades available
Every Renovent unit ships with a coarse filter (G3 or G4) as standard. Selected models also accept a finer M6 or F7 filter on the supply side, for extra protection against pollen, bacteria and urban smog — see each model page for the exact options.
Replacement schedule for Renovent filters
We recommend replacing Renovent filters every 3-6 months, sooner if you have pets, live near a busy road, or notice reduced airflow.
